(3) Downloading the firmware from the memory card
To download data written in a memory card (CompactFlash) to the printer, proceed as explained in this section.
CAUTION | Downloading firmware takes several minutes. Do not turn power off during |
| downloading. If downloading is interrupted by an accidental power failure, |
| etc., the system DIMM may have to be replaced. |
NOTE | The firmware program data must be stored to the root directory of the memory |
| card (CompactFlash). |
1Turn power switch off.
2Remove the two screws and then remove the slot cover. Insert the memory card in the printer’s memory card slot.
Memory card
Screws
Slot cover
3Turn power switch on.
4The printers starts and finishes downloading automatically.
5Confirm that downloading was finished normally by the LED indicator. (See the table below.)
6Turn power off.
7Remove the memory card and then secure the slot cover by using two screws.
8Turn power on again. Check the printer gets ready.
Confirm the status page shows the new firmware version (See Service information on the status page on page
