Lenovo 3797 manual
1 Handle
2 Latch
3 Filler panel handle

vAll hot-swap drives in the server should have the same throughput speed rating. Mixing hard disk drives with different speed ratings will cause all drives to operate at the lower throughput speed.

vThe ID that is assigned to each bay is printed on the front of the server above the drive bay.

Important: Do not install a SCSI hard disk drive in this server.

1 Handle

2 Latch

3 Filler panel handle

To install a drive in a hot-swap bay, complete the following steps.

Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes without either a drive or a filler panel installed in each bay.

1.Orient the drive as shown in the illustration.

2.Make sure that the tray handle is open.

3.Align the drive assembly with the guide rails in the bay.

4.Gently push the drive assembly into the bay until the drive stops.

5.Push the tray handle to the closed (locked) position.

6.If the system is turned on, check the hard disk drive status LED to verify that the hard disk drive is operating correctly.

After you replace a failed hard disk drive, the green activity LED flashes as the disk spins up. The amber LED turns off after approximately 1 minute. If the new drive starts to rebuild, the amber LED flashes slowly, and the green activity LED remains lit during the rebuild process. If the amber LED remains lit, see “Hard disk drive problems” on page 131.

Note: You might have to reconfigure the disk arrays after you install hard disk drives.

88ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Installation and User Guide