Select this choice to view the system board identifier, the revision level or issue date of the firmware, the integrated baseboard management controller and diagnostics code, and the version and date.
This choice is on the full UEFI Setup Utility menu only.
vSystem Settings
Select this choice to view or change the server component settings.
–Processors
Select this choice to view or change the processor settings.
–Memory
Select this choice to view or change the memory settings.
–Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output (I/O) ports. You can configure the serial ports, configure remote console redirection, enable or disable integrated Ethernet controllers, the SAS/SATA controller, SATA optical drive channels, PCI slots, and view the system Ethernet MAC addresses. If you disable a device, it cannot be configured, and the operating system will not be able to detect it (this is equivalent to disconnecting the device).
–Power
Select this choice to view or change power capping to control consumption, processors, and performance states.
–Integrated Management Module
Select this choice to view or change the settings for the Integrated Management Module.
-OS Loader Watchdog Timer
Select this choice to view or enable the OS Loader Watchdog Timer.
-POST Watchdog Timer
Select this choice to view or enable the POST Watchdog Timer.
-POST Watchdog Timer Value
Select this choice to view or set the POST Loader Watchdog Timer Value.
-Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt (NMI) occurs. Disabled is the default.
-Network Configuration
Select this choice to view the System Management Network Interface port, IMM MAC address, the current IMM IP address, and host name. Define the static IMM IP address, subnet mask, and gateway address, and specify whether to use the static IP address or have DHCP assign the IMM IP address, save the network changes, and reset IMM.
-Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
–Legacy Support
Select this choice to view or set legacy support.
-Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does not support UEFI Video Output Standards.
-Rehook INT
Chapter 6. Configuring the server 105