Lenovo 3797 manual Completing the installation

7.Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices and the server.

Note: You must wait approximately 20 seconds after you connect the power cord of the server to an electrical outlet before the power-control button becomes active.

8.Start the Setup utility and reset the configuration. v Set the system date and time.

vSet the power-on password.

vReconfigure the server.

See Chapter 6, “Configuring the server,” on page 103 for details.

Completing the installation

To complete the installation, complete the following steps:

1.If you removed the microprocessor 2 air baffle, replace the microprocessor 2 air baffle (see “Installing the microprocessor 2 air baffle” on page 51 ).

2.If you removed the DIMM air baffle, install it now (see “Installing the DIMM air baffle” on page 53).

3.If you removed either of the PCI riser-card assemblies, replace the riser-card assemblies now (see “Installing a PCI riser-card assembly” on page 43).

4.If you removed the server cover, replace it:

a.Make sure that all internal cables are correctly routed.

b.Place the cover-release latch
1 in the open (up) position.

c.Insert the bottom tabs of the top cover into the matching slots in the server chassis.

d.Press down on the cover-release latch to slide the cover forward and lock the cover in place.

e.Slide the server into the rack.

5.Install the server in a rack. See the Rack Installation Instructions that come with the server for complete rack installation and removal instructions.

6.To attach peripheral devices and connect the power cords, see “Connecting the cables” on page 101.

100ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Installation and User Guide