Lenovo 3797 manual Removing a hot-swap hard disk drive, Installing a hot-swap hard disk drive

1	Posts
2	Battery retention clip
3	Battery
4	Battery tray
5	Post
6	Rings

d.Press the posts into the rings and underneath the tabs on the remote battery tray.

e.Secure the battery to the tray with the battery retention clip.

2.Install the cover “Completing the installation” on page 100.

Removing a hot-swap hard disk drive

Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes without either a drive or a filler panel installed in each bay.

To remove a hard disk drive from a hot-swap bay, complete the following steps.

1.Read the safety information that begins on page vii, “Handling static-sensitive devices” on page 35, and “Installation guidelines” on page 33.

2.Press up on the release latch
2 at the top of the drive front.

3.Rotate the handle
1 on the drive downward to the open position.

4.Pull the hot-swap drive assembly out of the bay approximately 25 mm (1 inch). Wait approximately 45 seconds while the drive spins down before you remove the drive assembly completely from the bay.

5.If you are instructed to return the hot-swap drive, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Installing a hot-swap hard disk drive

Locate the documentation that comes with the hard disk drive and follow those instructions in addition to the instructions in this section.

The following notes describe the type of hard disk drive that the server supports and other information that you must consider when installing a hard disk drive:

vThe server supports eight 2.5-inch hot-swap hard disk drives installed on Ultra-Slim hard disk drive trays for 2.5-inch drives. An optional 4–drive-bay kit is available for 12–drive-capable server models. For a list of supported 2.5-inch hard disk drives, see http://www.lenovo.com/thinkserver.

Chapter 5. Installing optional devices and replacing customer replaceable units 87