4.If PCI
5.Remove the DIMM air baffle (see “Removing the DIMM air baffle” on page 52).
Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, open and close the clips gently.
6.Open the retaining clip 2 on each end of the DIMM connector.
7.Touch the
8.Turn the DIMM so that the DIMM keys align correctly with the connector.
9.Insert the DIMM into the connector 1 by aligning the edges of the DIMM with the slots at the ends of the DIMM connector. Firmly press the DIMM straight down into the connector by applying pressure on both ends of the DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly seated in the connector.
Important: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly inserted; open the retaining clips, remove the DIMM, and then reinsert it.
10.Install the DIMM air baffle (see “Installing the DIMM air baffle” on page 53).
11.Install PCI
If you have other devices to install or remove, do so now. Otherwise, go to “Completing the installation” on page 100.
If you have other optional devices to install or remove, do so now. Otherwise, go to “Completing the installation” on page 100.
Removing a hot-swap power supply
Important: If the server has two power supplies, and if you remove either of them, the server will not have redundant power; if the server power load then exceeds 675 W, the server might not start or might not function correctly.
To remove a power supply, complete the following steps.
Chapter 5. Installing optional devices and replacing customer replaceable units 69
