Lenovo 3797 manual

1 PCI riser-card assembly 2

2 PCI riser-card assembly 1

3 Alignment slots

4 Alignment brackets

5 PCI riser connector 1

6 PCI riser connector 2

vPCI riser connector 1: Carefully fit the two alignment slots on the side of the assembly onto the two alignment brackets in the side of the chassis; align the rear of the assembly with the guides on the rear of the server

vPCI riser connector 2: Carefully align the bottom edge (the contact edge) of the riser-card assembly with the PCI riser-card connector on the system board; align the rear of the assembly with the guides on the rear of the server.

10.Press down on the assembly. Make sure that the riser-card assembly is fully seated in the PCI riser-card connector on the system board.

11.Perform any configuration tasks that are required for the adapter.

If you have other optional devices to install or remove, do so now. Otherwise, go to “Completing the installation” on page 100.

Chapter 5. Installing optional devices and replacing customer replaceable units 59