Installing a CD-RW/DVD drive

To install the replacement CD-RW/DVD drive, complete the following steps.

1.Attach the drive-retention clip 1 to the side of the drive.

2.Slide the drive into the CD/DVD drive bay (using the alignment pins 2) until the drive clicks into place.

3.Install the cover (see “Completing the installation” on page 100).

4.Slide the server into the rack.

5.Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices and the server.

Removing a tape drive

The following illustration shows how to remove an optional tape drive from the server.

1 SAS riser card

To remove a tape drive from the server, complete the following steps:

1.Read the safety information that begins on page vii and “Installation guidelines” on page 33.

2.Turn off the server and peripheral devices, and disconnect the power cords and all external cables.

3.Slide the server out of the rack; then, remove the cover (see “Removing the cover” on page 37).

4.Open the tape drive tray release latch 3 and slide the drive tray out of the bay approximately 25 mm (1 inch).

5.Disconnect the power and signal cables from the rear of the tape drive.

90ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Installation and User Guide

Page 106
Image 106
Lenovo 3797 manual Installing a CD-RW/DVD drive, Removing a tape drive