LG Electronics C Series manual Moving to other groups

Chapter 5. Programming keypad

5.3 Moving to other groups

zThere are 4 different parameter groups as shown below.

Drive group	Function
	group 1
	Function
	group 2

I/O group

Drive group	Basic parameters necessary for the inverter to run. Parameters such
	as Target frequency and Accel/Decel time are settable.
Function group 1	Basic function parameters to adjust output frequency and voltage.
Function group 2	Advanced function parameters to set parameters for such as PID
	Operation and second motor operation.
I/O (Input/Output)	Parameters necessary to make up a sequence using Multi-function
group	input/output terminal.

zMoving to other parameter groups is only available in the first code of each group as the figure shown below.

Moving to other groups using the Right (X) key		Moving to other groups using the Left (W) key
	*		*
	Drive group		Drive group
I/O group	Function	I/O group	Function
	group 1		group 1
	Function		Function
	group 2		group 2

*Target frequency can be set at 0.0 (the 1st code of drive group). Even though the preset value is 0.0, it is user-settable. The changed frequency will be displayed after it is changed.

27