| 1 | -. Apply AC input power to the inverter. |
| 2 | -. When 0.0 is displayed, press the Up (S) key three times. |
| 3 | -. drv is displayed. Operating method is selectable. |
| -. Press the Prog/Ent (z) key. |
| |
| 4 | -. Check the present operating method (“1” is run via control terminal) |
| -. Press the Prog/Ent (z) key and then Down (T) key once. |
| |
| 5 | -. After setting “0”, press the Prog/Ent (z) key. |
| 6 | -. “drv” is displayed after “0” is blinking. Operation method is set via the Run key on the |
| keypad. | | |
| | -. Press the Up (S) key once. |
| 7 | -. Different frequency setting method is selectable in this code. |
| -. Press the Prog/Ent (z) key. |
| |
| 8 | -. Check the present frequency setting method (“0” is run via keypad). |
| -. Press the Up (S) key twice. |
| |
| 9 | -. After checking “2” (frequency setting via potentiometer), press the Prog/Ent (z) key. |
| 10 | -. “Frq” is displayed after “2” is blinking. Frequency setting is set via the potentiometer on |
| the keypad. | | |
| | -. Turn the potentiometer to set to 10.0 Hz in either Max or Min direction. |
| | -. Press the Run key on the keypad. |
| 11 | -. FWD lamp begins to blink and accelerating frequency is displayed on the LED. |
| -. When run frequency 10Hz is reached, 10.0 is displayed as shown left. |
| |
| | -. Press the STOP/RST key. |
| 12 | -. FWD lamp begins to blink and decelerating frequency is displayed on the LED. |
| -. When run frequency is reached to 0Hz, FWD lamp is turned off and 10.0 is displayed as |
| | shown left. | | |
| | L1(R) | U | 10 Hz |
| | 220VAC | V | Motor |
| | L2(S) |
| | W | |
| | | |
