LG Electronics C Series manual Apply AC input power to the inverter

Chapter 6. Basic operation

Frequency Setting via potentiometer & operating via terminals

1	-. Apply AC input power to the inverter.
2	-. When 0.0 appears Press the Up (S) key four times.
3	-. Frq is displayed. Frequency setting mode is selectable.
	-. Press the Prog/Ent (z) key once.
4	-. Present setting method is set to 0 (frequency setting via keypad).
	-. Press the Up (S) key twice.
5	-. After 2 (Frequency setting via potentiometer) is set, press the Prog/Ent (z) key once.
6	-. Frq is redisplayed after 2 stops blinking.
	-. Turn the potentiometer to set to 10.0 Hz in either Max or Min direction.
	-. Turn on the switch between P1 (FX) and CM (See Wiring below).
7	-. FWD lamp begins to blink and the accelerating frequency is displayed on the LED.
	-. When run frequency 10Hz is reached, the value is displayed as shown left.
	-. Turn off the switch between P1 (FX) and CM terminals.
8	-. FWD lamp begins to blink and the decelerating frequency is displayed on the LED.
	-. When the run frequency is reached to 0 Hz, FWD lamp is turned off and 10.0 is
	displayed as shown left.

MIN MAX

L1(R)	U		10 Hz
220VAC	V	Àüµ¿±â
L2(S)
	W
		Freq.
P
P1		P1(FX)-CM	ON	OFF
N
	P1(FX)
G	CM

Wiring

Operating pattern

40