Chapter 5. Programming keypad
How to monitor fault condition in Drive group
Over- | During |
current | Accel |
|
trip | Current |
|
| Frequency |
-. This message appears when an Overcurrent fault occurs. -. Press the Prog/Ent (z) key once.
-. The run frequency at the time of fault (30.0) is displayed. -. Press the Up (S) key once.
-. The output current at the time of fault is displayed. -. Press the Up (S) key once.
-. Operating status is displayed. A fault occurred during acceleration. -. Press the STOP/RST key once.
-. A fault condition is cleared and “nOn” is displayed.
When more than one fault occur at the same time,
Motor overheating
Over voltage
Over current
-. Maximum three faults information is displayed as shown left.
