Installation
Installing the PARTNER MAIL VSModuleTo install the voice messaging system module in the communications system’s
control unit:
1.
2.
Turn off power to the communications system’s control unit: either pull out
the main circuit breaker on the upper right rear corner of the control unit
or move the on/off switch to the “off” position, or remove the power cord
from the AC outlet.
CAUTION:
Failure to turn off power may damage the control unit and/or the
voice messaging system.
Install the voice messaging system module in the first available slot to the
right of the last installed 206 or 400 module. Do not install the voice
messaging system module in the first slot of the PARTNER Plus system
control unit or the PARTNER II or PARTNER 48 system primary carrier
(see Figure 2-1).
NOTE:
The voice messaging system module should always be installed
after the 206 and 400 modules to ensure consecutive extension
numbering. If the control unit is upgraded with more 206 or 400
modules, the voice messaging system module should be removed,
the new modules should be installed, and the voice messaging
system module should be replaced in the first available slot after
the 206 and 400 modules. The VMS Hunt Group Extensions
and Transfer Return Extensions must then be reprogrammed
(see Chapter 4).
On the PARTNER Advanced Communications System, you must install
the voice messaging system module in the slot to the right of the
PARTNER ACS module in the 2-slot carrier. If your system has a 5-slot
carrier, you may install the voice messaging system module in any slot
except the center slot (see Figure 2-2).
Push slowly but firmly in the center of the module until the module locks
into place, and is attached to the rear of the backplane. Do not force the
module. If it does not insert easily, remove the module, clear any
obstruction, and reinsert it.
2-2