Initial Programming
Communications System
Programming
Automated Attendant Service
Before you begin, locate Forms A, B1, and C of the System Planner for the
communications system.
Refer to Form A, Page 1, Line Coverage, to see if any lines are checked for
VMS–AA. If so, use this section to program Automated Attendant Service;
otherwise, skip to “Call Answer Service.”
Group Call Distribution
Use this procedure to specify the outside lines on which Automated Attendant
Service is required.
To assign VMS-AA lines specified on Form A, Page 1, Line Coverage, to Hunt
Group 7:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
At extension 10*, press [
Feature
] [
0
] [
0
] [
System Program
] [
System Program
].
Enter the System Password if required.
Press [
#
] [
2
] [
0
] [
6
]
†
.
At the
Group:
prompt, press [
7
].
At the Line: prompt, enter the first VMS-AA line specified in the Line
Coverage column of Form A, Page 1.
Press [
Next Data
] until the display reads
1 Assigned.
To program another line, press [
Next Item
] or [
Prev Item
] until the appropriate
line number displays.
Press [ Next Data ] until the display reads 1 ASSigned.
Repeat Steps 7 and 8 for each VMS-AA line on Form A.
Continue with “VMS Hunt Delay” below.
*Some systems also allow programming from extension 11. Check the Programming and Use
guide for the communications system.
†In some cuntries, the procedure code for Group Call Distribution is #205. Check the
Programming and Use guide for the communications system.
4-19