Initial Programming
Initial Communications System Setup
You must perform the first two procedures for every installation. The procedure
for Outgoing Call Restriction is strongly recommended to ensure system
security. For the following procedures, you need to know the extension numbers
associated with the PARTNER MAIL VS system module. Figures 2-1 and 2-2
(in Chapter 2) show the possible extension numbers. For the extension numbers
appropriate to this installation, locate Form B1 of the System Planner for the
communications system.

VMS Hunt Group Extensions

You must use this procedure to assign the extensions associated with the voice
messaging system module to Hunt Group 7. This Hunt Group, which is called
the VMS Hunt Group, is used exclusively for the voice messaging system.
To assign the PARTNER MAIL VS extensions specified on Form B1 to Hunt
Group 7:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
At extension 10*, press [
Feature
] [
0
] [
0
] [
System Program
] [
System Program
].
Enter the System Password, if required.
Press [
#
] [
5
] [
0
] [
5
].
At the
Group:
prompt, press [
7
].
At the
Extension:
prompt, enter the first PARTNER MAIL VS extension
number specified on Form B1.
Press [
Next Data
] until the display reads
1 Assigned.
Press [
Next Item
] or [
Prev Item
] until the next PARTNER MAIL VS extension
number specified on Form B1 displays.
Press [
Next Data
] until the display reads
1 Assigned.
If additional PARTNER MAIL VS extensions are shown on Form B1,
repeat Steps 7 and 8 for each one.
Continue with “Transfer Return Extensions” on the next page.
*Some systems also allow programming from extension 11. Check the Programming and Use
guide for the communications system.
4-3