Dual In-Line Memory Module152

Installation
Attention
It’s very important to protect the printer controller board and the DIMM from
elec tr ostatic damage. Befo re performing t his pr ocedur e, r eview t he anti static cau tion
on page 151. Always handle circuit boards by the edges only.
1Ensure that the printer is turned off and the power cord an d all interface cables are
disconnected.
2Remove the printer ’s controller board.
Loosen five screws and, using the tab on the top
of the conne ctor panel, pull the co ntr oller b oard
from the printer.
3Position the controller board on a flat surf ace.
4Insert the new DIMM straight down into the
DIMM connector until the latches snap into the
locked position.
Observe the keyed side of the DIMM to align it
with the connector. When seated, the DIMM
stands upright, firmly in place. If you cannot
snap the DIMM into place, do not force it.
Reposi tion it , making sur e that the bottom of the
DIMM is seated completely in the connector.
 If you need to remove the DIMM, using both
thumbs, pul l the latches (one on each side of the
DIMM connector) outw ard. Lift the DIMM
straight out of the DIMM connector.
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
................................................ ........................ ..........
................................................ ........................ ..........