Napco Security Technologies GEM-P3200 quick start CS Reporting Codes Address 0870, Areas

WI818G 10/05 Page 25

CS REPORTING CODES (ADDRESS 0870 -0904)

SYSTEM REPORTING		ADDRESS		SYSTEM REPORTING	ADDRESS
		0870-0880			0890-0897
CODES				CODES
	LEFT	ADDR	RIGHT		LEFT	ADDR	RIGHT
Test Timer		0870		Digital Dialer Test		0890
						0891
Alarm Supervisory		0871		RESERVED
Bus Failure		0872		RESERVED		0892
						0893
Memory Failure		0873		Service Message
						0894
Low Battery		0874		Program Change
						0895
AC Failure		0875		RF Receiver Trouble
						0896
EZM Tamper		0876		RF Tamper
						0897
Sensor Watch		0877		RF Trouble
RESERVED	blank (•)	0878	blank (•)	[Default = blank (•) blank (•) from address 0870-0904]
RESERVED	blank (•)	0879	blank (•)
Telco Line Failure		0880

KEYPAD REPORTING		ADDRESS
		0900-0904
CODES
	LEFT		ADDR	RIGHT
Ambush			0900
Panic			0901
Fire			0902
Auxiliary			0903
Tamper			0904

CS SYSTEM REPORTING CODES:

1.Enter in corresponding address location (left and right digits).

NOTE: Left digit is the first digit and right digit is the second digit in a two digit CS receiver format.

2.Valid entries are: 1-9, 0 and B-F.

NOTE: A is not permitted.

3.To disable a code leave boxes blank (•). NOTE: Dark shaded data value box shows option not available.

4.Press Uor Dto save.

CS REPORTING

CAUTION: For all 2-Digit Reporting Formats (see CS Receiver Format Options), use the following:

	Reporting	ADDRESS Loc.
		LEFT	RIGHT
	Code
		1	2
2nd Digit of Reporting Code			1st Digit of Reporting Code

Example: The 2-digit reporting code as shown is “21”.

CS AREA & SYSTEM REPORTING OPTIONS (ADDRESS 1024 - 1027)

		AREAS 1	2
CS Area Reporting Options	ADDRESS	A1	A2
		1	2
DISABLE OPENING REPORTS	1024
DISABLE CLOSING REPORTS	1025

CODES & CS REPORTING OPTIONS

1027	CS System Report Options
Default			Option
OFF		1	Backup Report on Telco 2
OFF		2	Touch-tone Dialing Only *
ON		3	Touch-tone Dialing w/Rotary Backup *
OFF		4	Transmit “402” Opening/Closing Code
OFF		5	Cancel Next Test Timer on any Report
OFF		6	Disable Wait for Silence
OFF		7	Disable Wait for Handshake
OFF		8	Handshake for Local Telemetry

CS AREA & SYSTEM REPORTING OPTIONS:

1.Select the desired option entering the option number (1-8) for each digit.

2.Enter corresponding option number in address location.

NOTE: Dark shaded data value box shows op- tion not available.

3.Press Uor Dto save.

*NOTE: If neither TouchTone Dialing nor TouchTone w/Rotary Backup is selected, then system defaults automatically to Rotary Dialing. Leave blank (•) to select Rotary Dialing.

LNAPCO Security Systems XGEM-P3200 Programming Instructions