Napco Security Technologies GEM-P3200 quick start Zone Descriptions GEM-RP1CAE2 / GEM-K1CA Keypads

USER PROGRAM MODE

Page 54WI818G 10/05

ZONE DESCRIPTIONS (GEM-RP1CAE2 / GEM-K1CA KEYPADS)

	Enter an identifying description for each zone. Characters are selected by
01-
	pressing keypad buttons multiple times, "Cell Phone" style. Buttons 1
	through 9plus 0and Gare used, as per the following table:

(Direct Entry)

PRESS:			CHARACTERS DISPLAYED	HOLD G			CHARACTERS DISPLAYED
			IN SEQUENCE	AND PRESS:			IN SEQUENCE
[1]			ABC1	[1]			abc1
[2]			DEF2	[2]			def2
[3]			GHI3	[3]			ghi3
[4]			JKL4	[4]			jkl4
[5]			MNO5	[5]			mno5
[6]			PQR6	[6]			pqr6
[7]			STU7	[7]			stu7
[8]			VWX8	[8]			vwx8
[9]			YZ90	[9]			yz90
[	0	]	(SPACE) - . ( ) , / : ? #	[	0	]	(International Characters)

Press [A] to move cursor right.

Press [B] to move cursor left.

Notes:

1.After releasing the number button for 1 second, the character will be accepted and the cursor advanced to the right.

2.After releasing the number button, if a new number button is pressed before the 1 second window expires, the cur- rent character will be accepted and the cursor automatically advanced to the right. The first of the 4 characters of this new number button will be displayed.

3.To erase an existing entry, use [A] or [B] to move the cursor below the character to be changed. Enter a new character to overwrite the old.

4.To generate lowercase characters, the [G] button must be pressed and held down while pressing the number button. If the [G] button is released during the 1 second window, the current character will change to upper- case. Press Uto save.

To proceed to the next description, place the cursor under the Zone Number (e.g. “1”) and press the number that corre- sponds to the zone. Repeat this procedure until all zones have been programmed. After programming the user codes, press the NEXT button to proceed.

Enter Date

( / / )

(Direct Entry)

Enter Time

( : )

(Direct Entry)

Enter Date (Press the (R) button to set cursor.)

Enter the current date in the format MM/DD/YY, where MM = the month (01–12); DD=the day (01–31); and YY=the year. Press Uto save. Press

NEXT button to proceed.

Enter Time (Press the (R) button to set cursor.)

Enter the current time in the format HH:MMA/P, where HH=hours (01–12); MM=minutes (00–59). Select Am or Pm by pressing any number button,

then press Uonce again to save.

NOTE: To enter the date and time, GEM-RP1CAe2/GEM-K1CA keypad (version 6 or greater) must be used and “Enable Keypad Time/Date Display” (Address 3874) must be enabled.

XGEM-P3200 Programming Instructions LNAPCO Security Systems