Napco Security Technologies GEM-P3200 quick start Keypad Options Address 2425

WI818G 10/05 Page 37

KEYPAD OPTIONS (ADDRESS 2425 -2446)

ADDRESS 2425

Keypad 1 Type	LEFT	RIGHT
& Area
Assignment

[Default = blank (•) 1]

Keypad 5 Type	ADDRESS 2429
	LEFT	RIGHT
& Area
	blank (•)
Assignment

[Default = blank (•) blank (•)]

Keypad 2 Type	ADDRESS 2426
	LEFT	RIGHT
& Area
	blank (•)
Assignment

[Default = blank (•) blank (•)]

Keypad 6 Type	ADDRESS 2430
	LEFT	RIGHT
& Area
	blank (•)
Assignment

[Default = blank (•) blank (•)]

Keypad 3 Type	ADDRESS 2427
	LEFT	RIGHT
& Area
	blank (•)
Assignment

[Default = blank (•) blank (•)]

Keypad 7 Type	ADDRESS 2431
	LEFT	RIGHT
& Area
	blank (•)
Assignment

[Default = blank (•) blank (•)]

Keypad 4 Type	ADDRESS 2428
	LEFT	RIGHT
& Area
	blank (•)
Assignment

[Default = blank (•) blank (•)]

KEYPAD TYPE & AREA ASSIGNMENT: Up to 7 keypads may be programmed, if they are connected.

NOTE: See Keypad Configuration Mode. By default from the factory, each keypad is configured as number 1.

1.Select keypad type & area assignment for each keypad from the tables shown.

2.Enter in corresponding right and left digit address locations above.

KEYPAD TYPE		KEYPAD AREA
LEFT	OPTION	ASSIGNMENT
blank	Burg Keypad	RIGHT	OPTION
(•)		blank (•)	Not Used
2	Wizard Keypad		Area 1
		1
			Area 2
		2

										KEYPAD
				KEYPAD OPTIONS
KEYPAD NUMBER	ADDR	KEYPAD	KEYPAD	KEYPAD	Rem. Acc.	AMBUSH	EASY	PANEL	TOUR
		FIRE	AUXILIARY	PANIC	Only *		ARMING	ACCESS	STATION
		1	2	3	4	5	6	7	8	OPTIONS
1	2440	default ON	default ON	default ON		default ON
2	2441	default ON	default ON	default ON		default ON
3	2442	default ON	default ON	default ON		default ON
4	2443	default ON	default ON	default ON		default ON
5	2444	default ON	default ON	default ON		default ON
6	2445	default ON	default ON	default ON		default ON
7	2446	default ON	default ON	default ON		default ON

[Defaults as noted for address 2440-2446]

KEYPAD OPTIONS: Select options for any of the 7 keypads.

*Note: For Remote Access Control only (no Arm/Disarm capability).

1.Select the desired option entering the option number (1-8) for each digit.

2.Enter corresponding option number in address location.

3.Press Uor Dto save.

NOTE: Dark shaded data value box shows option not available.

LNAPCO Security Systems XGEM-P3200 Programming Instructions