Napco Security Technologies GEM-P3200 quick start Accessing User Program Mode, User Codes

WI818G 10/05 Page 53

ACCESSING USER PROGRAM MODE

1.Press EEEEEER

New Panel (Default User Code = 123)

Existing Panel (Any Code with User Program Option Enabled)

2.Press Q Until “ACTIVATE PROGRAM Y/N” appears on LCD screen.

3.Press P To Enter User Program Mode

4.Press C To Exit User Program Mode when finished

USER CODES

Enter user code U01 123

GEM-K1CA Keypad (Direct Entry)

Up to 48 User Codes may be programmed. NOTE: In this mode, only the code is pro- grammable; the accompanying Area Options must be programmed in the Dealer Program Mode. By default, User 1 is enabled in Area 1 and 2; Users 2-8 are enabled in Area 1, Users 9-16 are enabled in Area 2; Users 17-48 are not enabled in any areas (see page 10).

Use the Rbutton to place the cursor over the User Number.

User Code

NOT USED

GEMINI

To Program User Codes

E n t e

r u s e

r c o d e

U 0 1 1 2 3

-

-

1.

Set Cursor Position using the

Rbutton.

S

S

TU

TA

2.

Enter 2-digit User Number (01-

A

NEXT/YES

R

1 2 3

U

P

48) directly using number but-

PRIOR/NO

tons (0-9).

B

4 5 6

Q

3.

Enter Code (1-6 digits) directly

AREA

using number buttons (0-9).

C

7 8 9 0

G

4.

Press the Ubutton to save

COMPUTERIZED SECURITY SYSTEM

each code.

NOTE: Press G0button to clear character at cursor.

To continue press Por Qbutton.

Programming User Codes with GEM-K1CA Keypad

USER PROGRAM MODE

Enter a User Number (01–48) using the number buttons. The cursor will then advance to the User Code and read the existing code, if any.

Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the cursor, press G0button.

Press the Ubutton to save the code in memory.

Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT button or the PRIOR but- ton.

LNAPCO Security Systems XGEM-P3200 Programming Instructions