Napco Security Technologies GEM-P3200 System Delays & Timeouts Address, Delays/Timeouts

WI818G 10/05 Page 19

SYSTEM DELAYS & TIMEOUTS (ADDRESS 0000-0002, 2402, 2406, 2414 & 3902)

EXIT	ADDRESS 0000	ENTRY	ADDRESS 0001	ENTRY	ADDRESS 0002
DELAY		DELAY 1		DELAY 2
		(sec.)		(sec.)
(sec.)
[Default = 060]		[Default = 030]		[Default = 030]

Select delay/timeout (0-255 seconds).

Aux.	ADDRESS 2402	ABORT	ADDRESS 2406
Output		DELAY
Access
		(sec.)
Control
Timeout		[Default = 000]
(sec.)
[Default = 000]
		Telephone		ADDRESS 2414
		Line Test
		Delay
		(x15 sec.)

[Default = 000]

EXIT/ENTRY DELAYS: Apply only to zones programmed with the following options “Exit/Entry 1, Exit/Entry 2, Exit/Entry Follower”. For UL Installations, the maximum exit delay is 60 seconds and the maximum entry delay is 45 seconds. NOTE: Sensor Watch Time Options are similar to above table, except in hours.

Press Uor Dto save.	CS Telco 3	ADDRESS 3902
	Report
	Delay
	(sec.)
	[Default = 000]

WARNING: Timers have uncertainty of +/-1 sec, so a "time" of 1 second may actually timeout IMMEDIATELY.

SYSTEM DELAYS & TIMEOUTS (ADDRESS 2407, 2408 & 4088)

SYSTEM

CHIME	ADDRESS 2407	AC Fail	ADDRESS 2408
TIME		Report Delay
(¼sec.)		(x10 min.)
[Default = 008 x ¼ sec. = 2 sec.]			[Default = 008]

1. Enter delay/timeout in corresponding address locations above.

Note: All entries for address 2407 are in quarter seconds (.25 seconds). Therefore, the default of 008 results in a 2 second timeout.

2. Press Uor Dto save.

Sensor Watch	ADDRESS 4088
Delay (Hr.)

[Default = 024]

DELAYS/TIMEOUTS

LNAPCO Security Systems XGEM-P3200 Programming Instructions