Napco Security Technologies GEM-P3200 quick start Important Note, NAPCO Security Group, Inc

THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN CONTROL PANEL FIRMWARE VERSION 50 OR LATER.

IMPORTANT NOTE

This manual supports the keypad programming of the GEM-P3200 control panel with the NAPCO "classic" GEM- RP1CAe2 keypad as well as the GEM-K1CA "K Series" keypad. The new "K Series" GEM-K1CA model offers the new STAY and AWAY buttons with simplified functionality, along with the new MENU and ENTER buttons. Note: While the instructions in this manual are depicted using the GEM-K1CA keypad, the manual applies to both the "classic" and the "K Series" keypads.

Program Mode is the same for both keypads--only the button names have changed, as follows:

•The Abutton and the Rbutton operate identically (in Program Mode) for both keypads.

•The Dbutton and the Ubutton operate identically (in Program Mode) for both keypads.

•The button and the button operate identically (in Program Mode) for both keypads. The words "NEXT/YES button" are used in this manual.

•The button and the button operate identically (in Program Mode) for both keypads. The words "PRIOR/NO button" are used in this manual.

For consistency, it is recommended that all keypads either be all "classic" or all "K Series"--both keypad types should not be used in one alarm system.

CHANGES FROM PREVIOUS EDITION

The following changes have been made to this manual (WI818G) since the previous edition (WI818F).

New addresses added to accommodate the GEM-ACM1D / GEM-2D Access Control Accessories, as follows:

•Enable ACM Access

•ACM Zone Options

•ACM Global Flags

•ACM Timeouts

•ACM Door Area Options

•ACM Scheduled Free Access

•Enable Panel Options

•Emergency Free Access

•Keypad Home Area / ACM Door #1 Area (Hex)

•Addition to the Easy Program Menu instructions, "Enter Proximity Card Users".

Existing addresses were changed and new addresses were added to accommodate the NAPCO NetLink™ NL-Mod device, as follows:

•For each telephone number desired, enable "Report to TCP/IP Receiver or AES" for Telco 1, Telco 2 and Telco 3.

•Enable "Callback Telephone No. Select". Enter either "1" for Callback Telephone Number 1 or "2" for Callback Telephone Number 2.

•Enable "Handshake for Local Telemetry"

•Enable "TCP/IP Communications"

•Enable "TCP/IP Panel/Site Initiated Functions"

NAPCO Security Group, Inc.,

333 Bayview Avenue, Amityville, New York 11701 For Sales and Repairs, call toll free: (800) 645-9445

For direct line to Technical Service, call toll free: (800) 645-9440

Internet: http://www.napcosecurity.com