NCR 7870 manual Operating Instructions, Power Up, Scanner Only Models, Scanner/Scale Models

Chapter 6: Operation 6-7

Operating Instructions

Power Up

The 7870 has no ON/OFF switch. The checkstand should be equipped with a circuit breaker switch during site preparation. The switch should be easily accessible and near the operator.

Power up the NCR 7870 on by turning the circuit breaker switch to ON. The NCR 7870 performs diagnostic checks during the power up procedure. If a scale error occurs, the yellow Status Indicator will light and an error code will appear on the NCR 7825 Remote Display or Integrated Display. If a scanner error is detected, and error tone will sound and the red and green Status Indicator lights will flash a code.

In the event of a problem in the power up process, call a supervisor, service company, or the NCR Customer Service Center for assistance.

Scanner Only Models

For the 1000 and 3000 models, if no error occur during power up the unit will enter Startup Mode. The red Status Indicator will flash, the green Status Indicator will flash, and a tone will sound. The red Status Indicator will then light. The unit is ready for use.

Scanner/Scale Models

For the 2000, 4000, and 4500 models, if no errors occur during power up the unit will enter Startup Mode. The red Status Indicator will flash and all segments on the display (remote or integrated) will be turned on for five seconds. The green Status Indicator light will flash , a tone will sound, and the display will show SCALE READY 0.000 kg or SCALE READY 0.00 lb. The red Status Indicator will light. The unit is ready for use.

The Scanner/Scale models should warm up for five minutes before being put into use.