NCR 7870 manual Mode 2 Real Time, 1136

7-60 Chapter 7: Programming

C3 03.4

1136

Tally Count 3

3.4% of Good Reads

Tally Count = 1136

Note: These displays alternate every three seconds.

16566

Scanning the Mode 1 tag again changes the display sequence to the next tally count. Continue to scan the Mode 1 tag to view all tally counts. The tally count information is displayed in order according to the tally count number (C1 – C5).

Exit Mode 1 by pressing the Scale Zero Button on the Operator Display Panel or by scanning the Mode 2 tag.

Mode 2 - Real Time

Enter Mode 2 by scanning the Mode 2 tag.

The scanner goes off-line and disables the scale so that the integrated display or the NCR 7825 Remote Display can show Ready 4 label. Every subsequent scan until the scanner is powered off (or the Scale Zero Button is pressed) causes the scanner to indicate the status of label readability. The scanner can recognize missing bars in labels, highly over/under printed labels, missing margins, or a no-read condition.

If you scan a UPC/EAN label for analysis, the display shows label followed in one second by the display of the first half of the UPC/EAN label. If the label is a version E, no second half is displayed, since the E label is only six digits in length. After another two-second pause, the display shows CODE xx where "xx" is a code number to indicate one of the following.