Configuring Memory and Other Baseboard Settings

Configuring the

Sample Configurations

4.Select SCSI Device Configuration and set the parameters as follows:

SCSI Device ID (tab to desired device)
Initiate Sync Negotiation	[yes]
Maximum Sync Transfer Rate	[20]
Enable Disconnection	[yes]
Initiate Wide Negotiation	[yes]
Send Start Unit Command	[yes]

5.Press [Enter] to return to previous menu.

6.Select Advanced Configuration Options and set the parameters as follows:

Host Adapter BIOS (Config Util...)	[Enabled]
Support Removable Disks...	[Boot Only]
Extended BIOS Translation...	[Enabled]
Display <CTRL-A> Message During	[Enabled]
BIOS Initialization...
Multiple LUN Support	[Disabled]
BIOS Support for More than 2...	[Enabled]

7.Press [Enter] to return to previous menu.

8.Press [Esc] until prompted to save configuration. Save the configuration and the system reboots.

Sometimes the EISA Configuration Utility will not boot. If this happens, perform the following procedure:

1.Using the BIOS Setup Utility, disable all PCI adapters.

2.Boot the EISA Configuration Utility.

C-9