NCR S10XL manual Configuring the System Settings

Configuring the System Settings

Sample Configurations

Sample RAID Configuration

4.Strap the four 4 GB wide drives as SCSI IDs 0, 1, 2, 3. Plug them into the hot plug backplane in drive bays 5, 6, 7, and 8 (bottom four drive bays).

5.Install the memory SIMMs in banks one and two on the system baseboard (installed in groups of two SIMMs).

6.Install the PCI Ethernet Adapter in PCI slot 1 (topmost PCI slot).

7.Install the PCI Token Ring Adapter in PCI slot 2.

8.Install the PCI RAID Adapter in PCI slot 3.

The procedure is the same as the procedure for configuring the system settings in the Standard Configuration. The procedure is repeated here for your convenience.

To configure the system settings, follow these steps:

1.Turn on power to the system. Observe that the memory test is executed (memory addresses should be rapidly displayed in upper left-hand corner of screen). Ignore any memory size mismatch error displayed on the screen.

2.Press [Control] + [Alt] + [Esc] when prompted to enter the BIOS Setup Utility.

3.Select Load System Setup Defaults and press [Enter].

NCR S10XL Hot Plug Server User Guide C-13