Using the BIOS Setup Utility

Basic System Configuration

Communication Settings

The Communication Settings parameters let you set the baud rate, parity, stop bit and data length for the first serial port (COM 1). The values are as follows:

Baud rate: 300 to 38,400 bits per second (BPS)

Parity: odd, even, or none

Stop bit: 1 or 2 stop bits

Data length: 7- or 8-bit data word

There is one restriction on the options available for the communication status parameters. If your data length parameter is an 8-bit data word, you must select one of the following combinations:

1 stop bit and odd or even parity

2 stop bits and no parity

The default values are 9600 BPS, odd parity, 1 stop bit, and 8-bit data word.

This function enhances disk performance depending on Hard Disk Block Mode the fixed disk in use. If you set this parameter to

Enabled, it allows data transfer in block (multiple sectors) by increasing the data transfer rate to 256 bytes/cycle. If your system does not boot after enabling this parameter, change the setting to Disabled. Disable the parameter if your system disk does not support this function.

4-10

NCR S10XL Hot Plug Server User Guide

Page 62
Image 62
NCR S10XL manual Communication Settings