NCR S10XL manual Installing SIMMs

Configuring the System Board

Installing SIMMs

Installing SIMMs

Caution Read the ESD precautions section earlier in this chapter before proceeding.

To install a SIMM, follow these steps:

1.Slip a SIMM at a 45o angle into a socket with the component side facing down.

2.Gently press the SIMM up until the pegs of the socket slip into the holes on the SIMM and the holding clips lock the SIMM into position.

Note: The SIMM should be at a 90o angle when installed on the baseboard or the dual processor CPU board. The SIMM should be at a 45o angle when installed on the ECC uni-processor CPU board.

Figure 2-2

Installing a SIMM

45°

NCR S10XL Hot Plug Server User Guide 2-9