NCR S10XL manual System Security Setup

Using the BIOS Setup Utility

System Security Setup

unauthorized users. Once you set this password, you have to type it whenever you boot the system.

To set the power-on password, follow the same procedures as in setting the setup password.

Note: To enable the password function, you must strap pins 1-2 on JP2 located on the system baseboard. The factory default setting disables the password function with pins 2-3 strapped. See Figure 2-1 in Chapter 2 for the location of JP2.

To change the existing password, enter the current password at the prompt when you boot the system, followed by a slash (/) and the new password you wish to specify. Again, be careful when typing the password as it does not appear on screen when you enter it.

NCR S10XL Hot Plug Server User Guide 4-25