
Hot Plug Backplane
Installation
| You can install a RAID controller and have it connected | ||
Using a RAID | |||
to the backplane. | |||
Controller Board | To install the backplane board when you are using a | ||
| |||
| RAID controller board, follow these steps: | ||
| 1. | Set the terminator switches on the backplane | |
|
| according to your planned SCSI channel | |
|
| configuration. Refer to the “SCSI Channel | |
|
| Configuration” section of this appendix for the | |
|
| channel configurations. | |
| 2. | Define the SCSI drive IDs by setting the SCSI ID | |
|
| jumpers on the hard disk drive. | |
| 3. | Install the backplane and secure it with eight screws. | |
|
| Refer to Figure | |
| 4. | Connect three power cables into the connectors at | |
|
| the back of the backplane board. | |
| 5. | Connect one end of each of the SCSI cables to the | |
|
| channels on the RAID controller board and the other | |
|
| end to the corresponding channels on the backplane. |
Figure D-9 shows how to connect the cables properly.
The SCSI cables are specifically marked and configured for each of the channels.
NCR S10XL Hot Plug Server User Guide |