NCR S10XL manual Configuring the System Settings

Configuring the System Settings

Sample Configurations

Sample Standard Configuration

3.Install the SCSI CD-ROM drive in the top front drive bay.

4.Connect power cables and SCSI cables to the SCSI CD-ROM drive. A Fast/Wide SCSI cable should already be connected from the Adaptec controller on the baseboard to the hot plug backplane.

5.Install the memory SIMMs in bank 1 on the system baseboard (installed in groups of two SIMMs).

6.Install the PCI Ethernet Adapter in PCI slot 1 (topmost PCI slot).

7.Install the PCI Token Ring Adapter in PCI slot 2 (below the PCI Ethernet adapter).

8.Install the ISA Video Board in EISA/ISA slot 2 (second EISA/ISA slot from the top).

To configure the system settings in the BIOS Setup Utility, follow these steps:

1.Turn on power to the system. Observe that the memory test is executed (memory addresses should be rapidly displayed in upper left-hand corner of screen). Ignore any memory size mismatch error displayed on the screen.

2.Press [Control] + [Alt] + [Esc] when prompted to enter the BIOS Setup Utility.

3.Select Load System Defaults and press [Enter].

NCR S10XL Hot Plug Server User Guide C-3