NCR S10XL manual Sample RAID Configuration

Sample Configurations

Sample RAID Configuration

Adaptec AIC-7870 BIOS v1.2

<<Press hot key for SCSI Select (TM)

Utility>>

(Refer to the Adaptec SCSI Manual for additional information about these settings).

2.Select SCSI Disk Utilities. Observe that the information that displays for the 2 GB disk drive and the CD-ROM drive is correct. If a low-level format on the 2 GB disk drive is needed, perform it now. It is usually not needed.

3.Select Configure/View Host Adapter Settings and set the parameters as follows:

SCSI Bus Interface Definitions
Host Adapter SCSI ID	[7]
SCSI Parity Checking	[Enabled]
Host Adapter SCSI Term	[Low ON/High ON]
Boot Device Options:
Boot Target ID	[0]
Boot LUN Number	[0]

4.Select SCSI Device Configuration and set the parameters as follows:

SCSI Device ID (tab to desired device)
Initiate Sync Negotiation	[yes]
Maximum Sync Transfer Rate	[20]
Enable Disconnection	[yes]
Initiate Wide Negotiation	[yes]
Send Start Unit Command	[yes]

C-18 NCR S10XL Hot Plug Server User Guide