
Using the System
Board SCSI
Connectors
Hot Plug Backplane
Installation
Installation
This section describes the hot plug backplane installation procedures.
If your system board has onboard SCSI connectors, you may connect them directly to the backplane channels using SCSI cables.
To install the backplane when you are using the SCSI connectors on the system board, follow these steps:
1.Set the terminator switches on the backplane according to your planned SCSI channel configuration. Refer to the “SCSI Channel Configurations” section earlier in this appendix for the channel configurations.
2.Define the SCSI drive IDs by setting the SCSI ID jumpers on the hard disk drive.
3.Remove all the old hard disk drive trays from the system, if any.
4.Install the backplane and secure it with eight screws.
NCR S10XL Hot Plug Server User Guide |