7-34 Troubleshooting

MAINTENANCE TOOLS

The Maintenance Tools is used for preventive maintenance, fault analysis, and several settings.

IMPORTANT: This guide contains procedures to use a floppy disk, however, your modular server is not equipped with factory-installed floppy disk drive and optical disk drive. Use the optional Flash FDD or

USB FDD.

Starting Maintenance Tools

Run the Maintenance Tools according to the following procedure.

1.Turn on peripheral devices and the modular server in this order.

2.Insert the NEC EXPRESSBUILDER DVD supplied with your modular server into the optical disk drive.

3.Press Ctrl, Alt, and Delete to reboot the modular server from the NEC EXPRESSBUILDER. (You may also turn off and then on again to reboot the modular server.)

System boots up displaying Boot selection menu.

Tool menu (Normal mode): Select this menu to use the tool on the local console.

Tool menu (Redirection mode): Select this menu to use the tool from the remote console.

IMPORTANT: An initial selection of the menu is "Os installation". If any other menu is not selected, "Os installation" starts automatically 10 seconds after the Boot selection menu is displayed.