Notes on Using Your Modular Server 1-5

FOR PROPER OPERATION

Observe the following notes for successful operation of the equipment. Use of the equipment ignoring the notes will cause malfunctions or failures of the equipment.

Modular server

„The modular server assembly must be installed in the Module Enclosure.

„Install or remove modular servers one by one.

„Hold the portions covered with metal plates when a modular server is installed or removed. To carry a modular server, put it into the case in which the modular server was contained at the purchase and pack it into the package.

„The modular server is extremely sensitive to static electricity. Make sure to touch the metal frame of the equipment to discharge static electricity from your body before handling the modular server. Do not touch the modular server terminals or on-board parts by a bare hand and place the modular server directly on the desk.

„Check and adjust the system clock before the operation if any of the following conditions is applicable.

–After carriage of modular server

–After storage of modular server

–After the modular serveris entered into the pause state under the environmental condition enduring device operation (temperature: 10 to 40°C, humidity: 20 to 80%)

Check the system clock at the rough rate of once per month. When the system clock is installed in a system requiring high time precision, it is recommended to use a time server (NTP server).

If the system clock is remarkably delayed or advanced as the passage of time in spite of adjustment, contact your service representative to ask maintenance.

„Store the unit under the storage condition (temperature: –10 to 55°C, humidity: 20 to 80%, without condensation) to allow internal devices and the equipment to operate correctly in the next operation.

„Before turning off the power of a modular server, shutdown the modular server correctly.

„After turning off the power of a modular server, wait for at least 5 seconds before turning on.

„The modular server contains precision component that is easily affected by drastic temperature change. If the modular server is used after storage or relocation, make sure that the modular server is fully adapted to the operating environment.