GS700TP Smart Switch Software Administration Manual

“CST Configuration”

“CST Port Configuration”

STP Configuration

The Advanced STP Configuration screen contains parameters for enabling STP on the device. To configure STP on the device:

1.Click Switching > STP > Advanced > STP Configuration. The Advanced STP Configuration screen displays:

Figure 4-21

The Advanced STP Configuration screen contains the following fields:

Global Settings

Spanning Tree State – Select the STP state on the device. The possible field values are:

Enable – Enable STP on the device.

Disable – Disable STP on the device.

Status

Bridge Identifier – Displays the Bridge priority and MAC address.

Time Since Topology Change – Displays the amount of time that has elapsed since the bridge was initialized or reset, and the last topographic change that occurred. The time is displayed in a day-hour-minute-second format, such as 2 days 5 hours 10 minutes and 4 seconds. The current root port and current root cost display as zero when the device is not connected to the network.

4-28

Configuring Switching Settings

v1.0, December 2007

Page 94
Image 94
NETGEAR GS700TP manual CST Configuration CST Port Configuration