Nortel Networks 53r 5300 00 manual Configuring the RSA-II card, Highlight Static IP Address

Hardware configuration 35

11Press F6 to reset to factory defaults.

12Select Yes to reset the defaults.

13Press Esc until you return to the IBM ServerRAID Configuration Utility screen.

14Select Yes to save changes made.

15Press Esc to exit ServeRAID setup.

16Select Yes to save the changes and exit.

--End--

Configuring the RSA-II card

Use this procedure to configure nonsecure access for the RSA-II card.

Prerequisites

•The planar and ServeRAID BIOS have both been reset to the factory default settings.

•This procedure describes only the nonsecure configuration of the RSA-II card. For more information about configuring security for the RSA-II card, see Nortel AS 5300 Security (NN42040-601).

Procedure Steps

Step Action

1From the physical KVM console, reboot the AS 5300 server and press F1 to access the planar BIOS configuration utility.

2From the planar BIOS setup utility screen, select Advanced Setup.

3Select RSA-II Settings.

4Highlight DHCP Control and use the left and right arrow keys to select Use Static IP.

5Highlight Static IP Address.

6Press the backspace key until the IP address field is empty, and type the IP address of the RSA-II card. Use backspace key to correct any data entry errors.

7Highlight Subnet Mask and enter the subnet mask of the Ethernet interface of the RSA-II card (using the same method as for entering the IP address).

8Highlight Gateway and enter the default gateway of the Ethernet interface of the RSA-II card (using same method as for entering the IP address).

Application Server 5300

Nortel AS 5300 Installation

NN42040-300 01.04

4 November 2008

Copyright © 2007-2008 Nortel Networks