Connect the hardware 25

Figure 1

Front panel of the AS 5300 server

Figure 2

Rear panel of the AS 5300 server

Ethernet 1 and Ethernet 2 are the main Network Interface Card (NIC) ports that carry traffic for the primary application of the server. These ports are configured to run in redundant mode with one port active and the other on standby, so connect them to a redundant host switch.

The Remote Supervisor Adaptor (RSA-II) is a PCI card that provides an Ethernet interface for remote system management of the server. It includes an embedded Web server. When the server is secured, the RSA-II card Ethernet port provides HTTPS/SSH access to the RSA-II card for remote management of the server. This includes access to controls to manage the power state of the server and inspect physical attributes, as well as to gain encrypted remote access to the physical console of the server. This port is typically cabled to a port in a maintenance network, separate from the network used for the primary application of the server.

The COM1 serial port provides serial console access using an industry standard RS-232 serial cable and is typically connected to either a terminal server such as the MRV Models LX-40XX or it can be attached to a serial port on another computer using a null modem cable. If the COM1 serial

Application Server 5300

Nortel AS 5300 Installation

NN42040-300 01.04

4 November 2008

Copyright © 2007-2008 Nortel Networks

Page 25
Image 25
Nortel Networks 53r 5300 00 manual Connect the hardware