Nortel Networks 53r 5300 00 manual Configuring a system for individual accounts

Configuring accounts and passwords 53

Reply Y to accept the account method confirmation.

OR

Reply N to go back to the User Accounts screen and change selections.

Once the account method is confirmed, the installer displays the prompt to create the passwords. The password limitations and requirements appear on-screen.

5If you selected the option to use a shared password, the installer prompts you to create the shared password.

If you selected the option to configure a password for each preconfigured account, the installer prompts you to create a password for each preconfigured account.

6Create the user account passwords as prompted by the installer. Ensure the passwords meet the requirements displayed on-screen. The passwords must be entered again for confirmation.

The installer displays the system accounts configuration screen.

7Create passwords for each system account as prompted by the installer.

The installer displays the following message:

System Configuration Complete

8Press Enter to continue.

The installer applies the system configurations. This may take several minutes.

After the configuration has been applied, the server reboots. Login access is available at the physical server, through RSA-II remote control (if configured), and available SSH.

9If applicable, install platform patches.

--End--

Configuring a system for individual accounts

Use this procedure to configure an individual account.

Prerequisites

•You have completed the steps described in "Configuring the NTP, Syslog, and Audit Daemon settings" (page 47).

•For more information about installing Linux Maintenance Releases, see "Applying the Linux Maintenance Release " (page 92).

Application Server 5300

Nortel AS 5300 Installation

NN42040-300 01.04

4 November 2008

Copyright © 2007-2008 Nortel Networks