Panasonic AJ-HPM110E, AJ-HPM110P manual 119

	Item	Setting
				Settings and brief function description
FR	SUPER	FR	SUPER
No.	DISP.	No.	DISP.
		For AJ-HPM110P		Sets system frequency.
				0: 59.94Hz
		0000	59.94
		0001	50	1: 50Hz
				2: 23.98 Hz
		0002	23.98
				3: 24 Hz
		0003	24
				4: 29.97 Hz
		0004	29.97
				5: 23.98 Hz
		0005	59-23
				Receives 59.94 Hz input. Select this frequency to record 2:3 pull-down converted
		0006	60-24
				(24-frame signal) output from VariCam: AJ-HDC27 series camera, AJ-HPX2000/2100,
		0007	25
				AJ-HPX3000 or other camera.
		0008	60-25
				6: 24Hz
		For AJ-HPM110E
25	SYSTEM FREQ			Receives 60Hz input. Select this frequency to record 2:3 pull-down converted
		0000	59.94	(24-frame signal) output from VariCam: AJ-HDC27 series camera.
		0001	50
				7: 25Hz
		0002	23.98
				8: 25Hz
		0003	24
				Receives 60Hz input. Select this frequency to record a variable frame rate set to 25p
		0004	29.97
				from VariCam: AJ-HDC27 series camera.
		0005	59-23
				NOTE:
		0006	60-24
				• Changing this item will only cause the menu item to flash but the setting is not actually
		0007	25
				reflected to this unit. For the changes to take effect, turn the power off and turn it back
		0008	60-25
				on again.
				• 2: 23.98 Hz and 3: 24 Hz are available only when the AJ-YBX200G AVC-Intra codec
				board (optional board) is installed.
		0000	0H	59.94Hz 29.97Hz only
		0001	90H	Specifies whether or not HD output should advance 90H phase relative to SD REF input
				during SD REF input.
26	HD SYS H ADV			0: Outputs HD at the same phase as SD REF.
				1: HD output is output at a phase that is 90H advanced relative to SD REF.
				NOTE:
				• The audio output and TC output are output in the same phase as HD output.
				• At 720p, the phase difference is 120H.
		0000	OFF	Sets/releases the system file lock mode.
30	MENU LOCK	0001	ON	0: Releases the lock (file data can be changed)
				1: Lock is engaged (file data cannot be changed)

Setup

Setup: Item Settings 119