Rear Panel

9

15

14

13

12

11 10

8

5

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1

7

2

6

3

1.SERIAL DIGITAL COMPONENT AUDIO and VIDEO IN/OUT connectors

These connectors enable input and output of serial digital component audio and video signals.

◆NOTE:

•The input digital audio signals must be synchronized with the video input signals. Otherwise, the audio signals will be affected by noise.

•Use a 5C-FB or equivalent double-shielded cable to make connections to the SERIAL DIGITAL COMPONENT connector.

2.IEEE 1394 digital input/output

This is an IEEE1394 digital interface. It inputs/outputs IEEE1394 compressed digital signals that comply with the IEC61883-1, IEC61883-2 and SMPTE396M standards. Use 6-pin connectors. This connector does not support bus power.

◆NOTE:

•Use a double-shielded cable to make connections to the IEEE1394 digital input/output connector.

•AVC-Intra 50 and AVC-Intra 100 (optional) recording and playback do not support input/output via the IEEE 1394 connector.

•No input or output is available via the IEEE1394 connector when something other than 59.94 or 50 is selected in setup menu No. 25 SYSTEM FREQ.

45

4.ANALOG AUDIO IN connectors/impedance switches/CH2 input switches

Analog audio input connectors

The input impedance of CH1-2 to CH3-4 can be switched. The LINE, MIC and 48V switches make it possible to use CH2 as a microphone input.

LINE:

Line input for audio input signals from

 

audio device

 

 

MIC:

Audio input signal from microphone with

 

internal power supply (this unit does not

 

provide phantom microphone power).

 

 

+48 V:

Audio input signal from microphone with

 

external power supply (this unit provides

 

phantom microphone power).

 

 

5.Fan

Cools this unit. Install the unit making sure that the air vents are not blocked. If the fan stops due to a breakdown, “E-10” will appear on the counter display. While the unit will operate even when the fan has stopped, it should be shut down immediately.

6.AC IN socket

Connect the supplied power cord to a power outlet.

3.ANALOG AUDIO OUT connectors

Output analog audio signals.

26 Introduction: Control Reference Guide