Panasonic AJ-HPM110E, AJ-HPM110P manual 134

	Item	Setting
FR	SUPER	FR	SUPER		Settings and brief function description
No.	DISP.	No.	DISP.
		0000	OFF	59.94Hz	50Hz 29.97Hz 25Hz 60-25Hz only
		0001	ON
684	EDH(SD)			Specifies whether or not EDH is superimposed on SDI OUT signals.

0:Signals are not superimposed.

1:Signals are superimposed.

0000 OFF 59.94Hz 29.97Hz only

0001	AUTO	Specifies the operating mode for edge subcarrier reduction (ESR) in the playback circuit.
685 ESR MODE(SD)

0:ESR is forcibly set to off.

1:ESR is automatically turned on and off depending on operating mode.

	0000	OFF	59.94Hz	only
	0001	ON
			Specifies whether or not the closed caption signal that is superimposed on the SD SDI
			and analog composite input signals will be recorded.
			0: Not recorded.
688	CC REC		The EE output is also blanked.
			1: A closed caption signal that is superimposed on an input signal is recorded.

NOTE:

•When 1394 is selected as the input signal, the closed caption signal superimposed on the compressed input signal is recorded in its original form regardless of settings in this menu.

0000	NORMAL 59.94Hz	50Hz 29.97Hz 59-23Hz 60-24Hz 25Hz
0001	DARK	only
	60-25Hz
	Selects the compression method used during video recording.
689 COMP MODE	0: Records using normal compression processing.

1:Records video suppressing compression video distortion that is generated by dark areas that are about 10 IRE (70 mV) or less.

				NOTE:
				This setting is available in DVCPRO HD 720p mode recording.
		0000	OFF	Specifies whether or not UMID data should be recorded.
690	UMID REC	0001	ON	0: UMID data is not recorded.
				1: Recorded.
		0000	INT	Specifies the generation method of UMID information that is recorded when menu No.
		0001	EXT	690 UMID REC is set to on.
691	UMID GEN			0: Newly created UMID information is always recorded.
				1: Records UMID data superimposed on the input signal.
				Newly created UMID information is recorded when not superimposed on an input
				signal.
		0000	BLANK	Specifies the line that superimposes UMID data.
		0001	12L	NOTE:
		:	:	• You cannot select the same line as in menu No. 501 VITC POS-1 and No. 502
		0006	17L	VITCPOS-2.
692	UMID POS	:	:	• Holding down the SHIFT button and pressing the RESET button will not restore the
		0008	19L	factory defaults.
				• UMID data is output before recorded VANC data. To output VANC data, set UMID
				POS to a line other than that which superimposed the data or select “BLANK.”
				• During playback of DVCPRO HD native clip, UMID becomes NO-INFO.

134 Setup: Item Settings