1. Basic operations

Single SHIFT

Single SHIFT is used to switch the individual material of a PGM/A bus crosspoint button, PST/B bus crosspoint button or AUX bus crosspoint button from a front material to a rear material or vice versa.

Switching between the front material and rear material is done using the crosspoint button in which the SHIFT function is allocated.

The SHIFT function can be allocated to button No.1 or No.12.

ww Allocatingxthe SHIFT function

1 Press the button to light its indicator, and display the XPT menu.

2Use [F1] to display the XPT Setting sub menu.

3Use [F2] to select the button to which the SHIFT function is to be allocated using the Shift item.

Right

Button No.12

Left

Button No.1

Off

Function is not allocated.

4Use [F3] to select the operation to be performed when the [SHIFT] button is pressed using the Shift-Lock item.

Off

The rear material is selected only while the

 

[SHIFT] button is pressed.

On

The front material and rear material are

 

switched each time the [SHIFT] button is

 

pressed.

ppTo use the materials that have been set in the button to which the SHIFT function is allocated, either set the SHIFT function off or allocate the SHIFT function to another button.

ppIf the [SHIFT] button for “Single SHIFT” is pressed when the rear materials (13 to 24) have been selected using “All SHIFT”, the bus crosspoint buttons concerned will be switched to the front materials.

ppWhen the crosspoint buttons are held down, the button numbers and the names of the input materials assigned to the buttons are displayed on the built-in display in the form of a list for as long as the crosspoint buttons remain held down.

1-1-3. Selecting the bus mode

Select the A/B bus system or flip-flop system (PGM/PST system) from the setting menu.

1Press the sbutton to light its indicator, and display the Config menu.

2Use [F1] to display the Operate sub menu.

3Use [F2], and select the A/B or PGM/PST (flip-flop system) using the Bus Mode item.

A/B

When the fader lever is at side A, the signals

 

selected by the A bus are replaced PGM

 

materials.

 

When the fader lever is at side B, the signals

 

selected by the B bus are replaced PGM

 

materials.

PGM-A/

Using a flip-flop system, the signals selected

PST-B

by the A bus are always replaced PGM

 

materials, and the signals selected by the

 

B bus are always replaced PST materials.

PGM-B/

Using a flip-flop system, the signals selected

PST-A

by the B bus are always replaced PGM

 

materials, and the signals selected by the

 

A bus are always replaced PST materials.

1-1-4. Selecting the transition mode

Select the transition mode using the MIX and WIPE buttons.

1Press the [BKGD] button in the transition area so that its indicator lights in amber.

When the [BKGD] button and [KEY] button are pressed at the same time, both buttons are selected.

2Use the [MIX] and [WIPE] buttons in the transition area to select the background transition mode.

The indicator of the selected button lights in amber.

8