2. Input/output signal settings

2-1-12. Adjusting the DVI input signals

These are used to adjust the clock/phase and position of the DVI-D input signal.

Select the clock/phase and position of the signals when the DVI input board (AV-HS04M3) has been connected.

1On the Input sub menu, use [F2] to select the input to be set using the Select item.

Refer to “2-1. Input signal settings”.

2Use [F1] to display the DVI Phase sub menu.

3Use [F2] to adjust the clock phase of the analog input signals using the Clk Phs item.

While viewing the image quality, set the value at which the noise level is minimized.

4Use [F3] to adjust the horizontal position using the H-Pos item.

5Use [F4] to adjust the vertical position using the V-Pos item.

2-1-13. Automatic adjustment of the black level and white level (analog input signals)

The black level (offset) and white level (gain) of the analog input signals are adjusted automatically.

ppSet this when the DVI input board (AV-HS04M3) has been connected.

Depending on the computer used, there may be some deviation from the correct levels of the black level or white level.

To proceed with automatic adjustment to correct this deviation, display the black-and-white signals (BW.bmp) on the supplied CD-ROM or the full-screen black signals and full-screen white signals on the computer connected to the DVI input connector, and input these signals as the DVI input signals.

When using the black-and-white signals, position them so that the boundary between black and white comes to the center of the monitor screen.

When using the full-screen black signals or full-screen white signals, display the black or white in an area that covers at least 80 % of the screen from the screen center.

Before making any adjustments, follow the instructions given in the “Automatic adjustment of the black level” section.

Automatic adjustment of the black level

Input the black-and-white signals (BW.bmp) or full-screen black signals.

Use [F5] to select “Black” in the Auto item, and press [F5] to adjust the black level automatically.

“Auto Setting” is displayed on the built-in display while adjustments are being made.

Automatic adjustment of the white level

Input the black-and-white signals (BW.bmp) or full-screen white signals.

Use [F5] to select “White” in the Auto item, and press [F5] to adjust the white level automatically.

“Auto Setting” is displayed on the built-in display while adjustments are being made.

Initializing the adjusted values

Use [F5] to select “Init” in the Auto item, and press [F5] to return the adjusted values to their factory settings.

“Auto Setting” is displayed on the built-in display while adjustments are being made.

87