8. Programmable Features
Setting the time of alarm
1.Press {j}.
2.Press {e} or {v} repeatedly to display “SETTING HS”.
3.Press {>}.
4.Press {e} or {v} repeatedly to display “TIME ALARM”.
5.Press {>}.
6.Press {e} or {v} repeatedly to display “SET TIME”.
7.Press {>}.
8.Enter the desired hour/minute by selecting 2 digits for each (24 hour clock entry).
L To clear, press {C}.
9.Press {>}.
10.Press {e} or {v} repeatedly to select the desired setting.
“ONCE”: Alarm will ring only once.
“REPEAT DAILY”: Alarm will ring at the set time everyday.
“OFF” (default): Deactivates this feature.
11.Press {>} or {j}.
12.Press {ih}.
Note:
LTime alarm will sound for 3 minutes.
LTo stop the alarm, press any dialling buttons. L When in talk or intercom mode, the alarm will
not sound until the call is ended.
Changing the time alarm frequency
1.Press {j}.
2.Press {e} or {v} repeatedly to display “SETTING HS”.
3.Press {>}.
4.Press {e} or {v} repeatedly to display “TIME ALARM”.
5.Press {>}.
6.Press {e} or {v} repeatedly to display “SET ALARM”.
7.Press {>}.
8.Press {e} or {v} to select “ONCE”, “REPEAT DAILY” or “OFF”.
9.Press {>} or {j}.
10.Press {ih}.
Ringer option settings
You can select the following ringer settings.
Ringer volume: See page 21.
Ringer patterns for external calls / internal calls / paging / alarm: There are 20 patterns available for each ringer. To change the ringer patterns, proceed as follows.
1.Press {j}.
2.Press {e} or {v} repeatedly to display “SETTING HS”.
3.Press {>}.
4.Press {e} or {v} repeatedly to display “RINGER OPT”.
5.Press {>}.
6.Press {e} or {v} repeatedly to display the desired item.
For external calls, select “EXT RINGER”. For internal calls, select “INT RINGER”. For paging, select “PAGING”.
For alarm, select “ALARM”.
7.Press {>}.
8.Press {e} or {v} repeatedly to select the desired setting from pattern “1” (default) to “20”.
9.Press {>} or {j}.
10.Press {ih}.
Note:
LIf you select one of the melody ringer patterns, the ringer will continue to sound for 10 seconds when the caller hangs up before you answer. You may hear a dial tone or no one on the line when you answer a call.
Tone option settings
You can set the following tone/alarm on or off.
Key tone: Key tones, a confirmation tone or an error tone will sound. The default setting is “ON”.
Call waiting tone: A call waiting tone will sound when an external call is received during an intercom call. The default setting is “ON”.
Range warning alarm: An alarm will sound when you move out of range of a base unit. The default setting is “OFF”.
Battery low alarm: An alarm will sound when the batteries need to be charged. The default setting is “ON”.
1.Press {j}.
2.Press {e} or {v} repeatedly to display “SETTING HS”.
3.Press {>}.
56
