8. Programmable Features

6.Press {>}.

7.Enter the 4-digit handset PIN. L The default PIN is “0000”.

8.Press {e}.

9.Press {>} or {j}.

10.Press {ih}.

Note:

LBattery type selection (page 59) will not be reset.

LThe phonebook data (page 29) will be saved.

8.5Handset programming using the base unit PIN

{j}

{>}{e}{v} {ih} {C}

To exit programming, press {ih} any time.

Changing base unit PIN

The base unit’s PIN is set at the factory to

0000”. If you change the PIN, please write down your new PIN as the unit will not reveal the PIN to you. If you forget your PIN, consult your nearest Panasonic service centre.

1.Press {j}.

2.Press {e} or {v} repeatedly to display “SETTING BS”.

3.Press {>}.

LINPUT CODE” will be displayed.

4.Press {5}.

5.Enter the current 4-digit base unit PIN.

6.Enter the new 4-digit base unit PIN.

7.Enter the new 4-digit base unit PIN again to verify.

8.Press {ih}.

Setting call restriction

You can restrict selected handset(s) from dialling selected phone numbers. You can assign up to 10 call restriction numbers (up to 8 digits). If you dial a restricted number, the call will not be

connected and the restricted number will flash on the display.

1.Press {j}.

2.Press {e} or {v} repeatedly to display “SETTING BS”.

3.Press {>}.

L INPUT CODE” will be displayed.

4.Press {6}.

5.Enter the 4-digit base unit PIN. L The default PIN is “0000”.

L All the registered handset numbers are displayed.

L If you programmed previously, the pre- selected handset number flashes.

6.Press the desired handset number(s).

LThe selected handset number will flash.

LTo cancel the selected handset number, press the number again. The number will stop flashing.

7.Press {>}.

8.Enter the phone number to be restricted, up to 8 digits.

LDo not enter the same number as programmed for the fax activation code (feature #41, page 53).

9.Press {>} or {j}.

LTo enter other numbers, repeat steps 8 and 9 (up to 10 numbers).

10.Press {ih}.

Turning off/on call restriction

1.Press {j}.

2.Press {e} or {v} repeatedly to display “SETTING BS”.

3.Press {>}.

L INPUT CODE” will be displayed.

4.Press {6}.

5.Enter the 4-digit base unit PIN. L The default PIN is “0000”.

6.Press the desired handset number.

LHandset numbers will be displayed. Flashing numbers indicate call restriction is on; non-flashing numbers indicate call restriction is off. Press the desired handset number to turn off/on.

7.Press {>} or {j}.

8.Press {ih}.

Cancelling a call restricted number

1.Press {j}.

60

Page 62
Image 62
Panasonic KX-FC195AL manual Handset programming using the base unit PIN, Changing base unit PIN, Setting call restriction