10. Help
LThe ink film is slack or creased. Tighten it (see step 5 on page 15).
DIRECTORY FULL
LThere is no space to store new entries in navigator directory. Erase unnecessary entries (page 32).
FAX IN MEMORY
LThe unit has a document in memory. See the other displayed message instructions to print out the document.
FAX MEMORY FULL
LThe memory is full of received documents due to a lack of recording paper or a recording paper jam. Install paper (page 17) or clear the jammed paper (page 70).
LWhen performing memory transmission, the document being stored exceeded the memory capacity of the unit. Transmit the entire document manually.
HANG UP HANDSET
LHandset(s) is not hung up. Press {ih} on the handset(s).
MEMORY FULL
LWhen making a copy, the document being stored exceeded the memory capacity of the unit. Press {STOP} to clear the message. Divide the document into sections.
MESSAGE FULL
LThere is no room left in memory to record voice messages. Erase unnecessary messages (page 45, 49).
MODEM ERROR
LThere is something wrong with the modem circuit. Contact our service personnel.
NO FAX REPLY
LThe other party’s fax machine is busy or has run out of recording paper. Try again.
PAPER JAMMED
LA recording paper jam occurred. Clear the jammed paper (page 70).
PLEASE WAIT
LThe unit is checking that there is no slack or crease on the ink film. Wait for a moment while the check is completed.
POLLING ERROR
LThe other party’s fax machine does not offer the polling function. Check with the other party.
REDIAL TIME OUT
LThe other party’s fax machine is busy or has run out of recording paper. Try again.
REMOVE DOCUMENT
LThe document is jammed. Remove the jammed document (page 72).
SEND CANCELLED
LYou pressed {C} while the unit was in redial mode for fax transmission. The redialling was cancelled.
TRANSMIT ERROR
LA transmission error occurred. Try again.
UNIT OVERHEATED
LThe unit is too hot. Let the unit cool down.
10.3When a function does not work, check here
If you still have difficulties after following the instructions in this section, reset the unit. Disconnect the power cord and turn off the handset. Remove the batteries, then
10.3.1 General
I cannot make and receive calls.
LThe power cord or telephone line cord is not connected. Check the connections.
LIf you used a splitter to connect the unit, remove the splitter and connect the unit to the wall jack directly. If the unit operates properly, check the splitter.
The unit does not work.
LDisconnect the unit from the telephone line and connect the line to a known working telephone. If the working telephone operates
66
