9. Options
9.1Operating additional units
Additional handsets: Additional handsets are available for purchase (page 11). Up to 6 handsets can be registered to a single base unit. Using additional handsets allows you to have an intercom call while simultaneously conducting a call to an outside line.
LAdditional handsets have answering device controls printed on their cases, however, remote operation of the base unit’s answering device is not possible.
Additional base units: You can register and operate your handset with up to 4 base units. Each base unit forms 1 radio cell. If the individual base units are linked to the same telephone line then you can extend the operating range of the system by positioning the base units so that the two radio cells overlap. If the handset is set to “AUTO” in base unit selection (page 63), then in standby mode the handset will automatically swap to the second base if the range on the first base is exceeded. It is not possible to transfer calls between base units (only between handsets linked to the same base unit).
Example: Additional handsets registered to 2 base units.
2
1 | 4 |
3
5
Radio cell
Note:
LCalls are disconnected when the handset moves from one radio cell to another.
9.2Registering a handset to a base unit
The handset supplied with the base unit is already registered. If an optional handset is purchased, it must be registered.
LKeep the front cover page open for button locations.
Important:
LAfter pressing {LOCATOR/HOLD} in step 8, the rest of the procedures must be completed within 1 minute.
LCharge the optional handset batteries for 7 hours before initial use.
To exit programming, press {ih} any time.
1Press {j}.
2Press {e} or {v} repeatedly to display “SETTING HS”.
3Press {>}.
4Press {e} or {v} repeatedly to display “REGISTRATION”.
5Press {>}.
6Press {e} or {v} repeatedly to display “REGISTER HS”.
7Press {>}.
8Press and hold {LOCATOR/HOLD} on the base unit until the registration tone sounds. L It may take up to about 10 seconds until
the registration tone sounds.
L “REGISTRATION” will be displayed on the base unit.
L If all registered handsets start ringing (paging), press {LOCATOR/HOLD} to stop paging then start over again.
9Using the handset, press {e} or {v} repeatedly to select the desired base unit number available to register the handset, and press {>}.
10After “BS PIN” is displayed, enter the
11Press {>} or {j}.
LWhen a handset is registered successfully, a confirmation tone will sound and w will light.
9.2.1 Cancelling a handset
Each handset can cancel itself or another handset.
1Press {j}.
2Press {e} or {v} repeatedly to display “SETTING BS”.
3Press {>}.
L “INPUT CODE” will be displayed.
62
