Panasonic WJ-SX650 manual System Controller Display Information, WV-CU950/650

Notes:

•During the alarm acknowledgement (ACK) status (refer to p. 31), event information is highlighted.

•When two or more alarm events have occurred, "∗" is displayed beside the event.

•When an alarm occurs and its display mode setting is OFF (refer to p. 30), "#" is displayed beside the event information.

•When auto tracking is scheduled for a camera event, "#" is displayed beside the camera number.

•q to r can be displayed or hidden either altogether or separately. Refer to p. 36 Lists of Functions and Operations for details.

■System Controller Display Information

The following are the details on terminal mode operations. For PS·Data operations, refer to p. 48 OPERATION (OTHER THAN THE TERMINAL MODE) or the operating instructions of system controllers.

●WV-CU950/650

q w e

r t y

qMonitor Number

Mon01 to 32: Monitor number

wCamera Number

Cam001 to 999: Camera number

C-P0001 to 9999: Camera position number

eEvent

HDR01 to 16: Recorder number

Pre000 to 256 (Lighting for 3.0 seconds): Preset position

Note: Pre000 is the home position.

T-A0001 to 0256: Terminal alarm

C-A0001 to 0999: Camera alarm

R-A0001 to 0999: Recorder alarm

S-A0001 to 1024: Serial alarm

V-A0001 to 0999: Video loss

rBusy

Busy + monitor number (Blinking)

A selected monitor is controlled by a higher-level oper- ator. (Monitor busy)

Note: You cannot control the selected monitor, camera, and recorder.

Busy + camera/recorder number (Blinking)

A selected camera or recorder is controlled by a high- er-level user. (Camera/Recorder busy)

Note: You cannot control the selected camera or recorder.

tStatus

Alarm (Blinking): Alarm is occurring.

Alarm (Lighting): Alarm is acknowledged. (Refer to p. 31.)

Memory + preset position number (Blinking for 3.0 sec- onds): Preset position is registered.

ySequence Number

T-Seq01 to 32: Tour sequence number

G-Seq01 to 08: Group sequence number

Note: During sequence pause, "P" is displayed beside the sequence number.

G-Seq09 to 32: Group preset number

Note: This sign disappears when the camera is con- trolled.

Invalid (Blinking for 3.0 seconds): You have entered a wrong value.

Not Avail (Blinking for 3.0 seconds):

•You cannot select a monitor because of lower priori- ty.

•You have tried to activate a group sequence or group preset on a monitor not assigned.

Prohibited (Blinking for 3.0 seconds): You have tried an operation restricted by the level setting.

Alarm Buzzer/Button Buzzer Setting

With the setting activated:

•Alarm buzzer can sound when alarms occur.

•Button buzzer can sound when a button is pressed or an error message (Invalid, Prohibited, Level1 Fixed, etc.) is displayed on the LCD.

Refer to the operating instructions of system controller for settings.

14