Panasonic WJ-SX650 manual System Menu, Data Port Menu, 800 bps/9 600 bps/19 200 bps/38 400 bps

■SYSTEM

You will perform the system settings required to transmit data between the unit and connected devices. When you select SYSTEM on the top menu, the following menu is dis- played.

500	SYSTEM
510	DATA	PORTO
520	SERIAL PORT
	BCOMMUNICATION		STATUS	38400
	(8/	NONE/1)
530	VD2/DATA/CABLE		COMPENSATIONO
540	RS485	CAMERAO

●SYSTEM Menu

• DATA PORT

DATA PORT menu will be displayed. You will select the DATA port types according to the connected devices.

• SERIAL PORT

Select the communication speed of SERIAL port. (The fac- tory default is 38 400 bps.)

4 800 bps/9 600 bps/19 200 bps/38 400 bps

Other parameters (COMMUNICATION STATUS) are as fol- lows. (Setting change is not available.)

Data bit: 8 (bits)

Parity check: NONE

Stop bit: 1 (bit)

• VD2/DATA/CABLE COMPENSATION

VD2/DATA/CABLE COMPENSATION menu is displayed. You will perform the settings for VD2, camera control signal (DATA), and cable compensation.

• RS485 CAMERA

RS485 CAMERA menu is displayed. You will set the RS-485 port numbers and unit addresses for the RS-485 cameras.

●DATA PORT Menu

510 DATA PORT
		DATA	TYPE	COMM.
OUT	BOARD1	1	TMNL1	9600
		2	PSD	9600
		3	HDR1	9600
		4	HDR2	9600
OUT	BOARD2	5	TMNL5	9600
		6	TMNL6	9600
		7	HDR3	19200
		8	HDR4	19200
COMMUNICATION		STATUS	8/	NONE/1

DATA=DATA(TMNL/PCD/HDR)

• TYPE

Select the DATA port types according to the connected devices.

TMNL1 to 8: Select this when using the DATA port of sys- tem controller in the terminal mode.

PSD: Select this when using the DATA port of system con- troller in the PS·Data mode.

HDR1 to 4: Select this when connecting a recorder to the DATA port.

The available port settings are as follows.

DATA1: TMNL1 /PSD (The factory default is TMNL1.)

DATA2: TMNL2 (The factory default is TMNL2.)

DATA3: TMNL3/HDR1 (The factory default is HDR1.)

DATA4: TMNL4/HDR2 (The factory default is HDR2.)

DATA5: TMNL5 (The factory default is TMNL5.)

DATA6: TMNL6 (The factory default is TMNL6.)

DATA7: TMNL7/ HDR3 (The factory default is HDR3.)

DATA8: TMNL8/ HDR4 (The factory default is HDR4.)

Note: Only one DATA port can be set to PSD.

• COMM.

Select the communication speed. (The factory default is 9 600 bps.)

4 800 bps/9 600 bps/19 200 bps

Parameters of COMMUNICATION STATUS are as follows. (Setting change is not available.)

Data bit: 8 (bits)

Parity check: NONE

Stop bit: 1 (bit)

Note: When changing the communication speed, conform the communication speed settings to that of the con- nected devices.

52